Multi - Screen Acoustic Partition Wall / Temporary Walls Room Dividers

Product Description

Aluminum Frame Hanging Accordion Wooden Partition Walls Philippines

How to operate the wooden partition walls

First, how to open a multi-screen wooden partition walls routine operation should be gentle, and should pay attention to safety. Facing the screen station, use both hands to grab the screen and pull the screen in the direction of the rails; turn the screen in the direction of the rails.
 

After pushing the screen to its place, fix the screen. Tip: When pushing the wooden partition walls to the intersection, you should pay attention to the direction of the rail, and then gently push the screen along the rail to the position where it should be placed.
 

Second, how to fix a multi-directional wooden partition walls
 

Hold the screen with one hand, and put the handle into the hexagonal steel at 1100mm on the side of the screen, grasp the handle and turn it 180 degrees clockwise (or shake it continuously); the inside of the screen will pop up. Fix the screen.
 

Insert the handle into the groove on the side of the screen, and pull the handle upwards to open the expansion screen inside the screen to fix the screen. After putting the entire group of screens, check if the screen is straight? Whether it is on the same plane as the rail, if not straight, retract the upper and lower expansion seals and adjust until the screen is straight.
 

Third, how to operate multi-directional telescopic panel screen
 

Usually the last side of each group of screens is a retractable screen. Push the screen to the position where it should be placed. Then move the handle up and down inside the side material groove to pop up and down the active seal, and then put the handle on the screen. In the operating hole on the surface of the telescopic screen, rotate counterclockwise until the side telescopic aluminum plate is pressed against the wall.

The details of installing the wooden partition walls

(1)Size of wall: all the folding partition wall panels should be installed in accordance with the manufacturers recommendations.

(2)Cutting: all necessary hardware and accessories for a complete job installation are to be furnished by the contractor.

(3)Install the acoustic panels: the installation of acoustic panels should be carried out in a sequence from the left to the right, from upside to downside, the panels are cut to fit on site, traditional woodworking tools are suitable for cutting the panels, if panels are cut using a fine tooth table saw the panels should be cut face up to avoid scratching and at a much slower speed to avoid any tearout or chipping.

(4)Fix on keel:
Wooden keel fixing using nails, staples or screws into prefixed timber battens on the walls via the tongue and groove joint.It also can fixing by: light steel keel.